Then how should you usually maintain your vehicle to prevent oil leaks?
First: pay attention to the role of the liner.
Automobile static parts of the parts between the liner plays a leak-proof sealing role. If the material, production quality and installation do not meet the technical specifications, it can not play the role of sealing leakage, and even accidents.
Second: all kinds of fastening nuts on the car need to be tightened according to the specified torque.
Too loose pressure will not tighten the liner leakage; too tight and will make the screw hole around the metal bulge or will be screwed slippery buckle and cause oil leakage. In addition, the oil sump oil drain screw plug if not tightened or back to loose off, easy to cause the loss of oil, and then occurred "burned holding the shaft" machine damage accident.
Third: timely replacement of failed oil seals.
A lot of moving parts of the car will be improperly installed, the journal and oil seal edge is not centered, eccentric and dumping oil. Some oil seals will lose elasticity due to aging of rubber after too long a period of use.
Fourth: avoid one-way valve, air valve blocked.
This causes the case temperature rise, the oil and gas filled with the whole space, the discharge does not go out, so that the case pressure rises lubricant consumption increases and shortens the replacement cycle. Engine ventilation system blocked, increasing the piston's resistance to movement, so that oil consumption increases. Due to the role of the case inside and outside the case of air pressure difference, often caused by sealing the weak point of oil leakage. Therefore, the vehicle needs to be regularly inspected, unblocked and cleaned.
Fifth: properly address the various types of oil pipe joint seals.
Vehicle coupling nut is often disassembled, easy to slip wire broken buckle and loose, will cause oil seepage. Replace the coupling nut, use the grinding method to solve its taper sealing, so that the nut pressure to solve the seal.
Sixth: avoid hub oil dumping.
Hub bearing and cavity lubricating grease is too much, or its oil seal assembly is not proper, poor quality and aging failure; frequent braking caused by the hub temperature is too high; axle nuts loose, etc. will cause the hub dumping oil.
It utilizes the power generated by the electric motor to assist the motorist in power steering.The composition of the EPS is largely the same for different cars, although the structural components are not the same. It is generally composed of a torque (steering) sensor, electronic control unit, electric motor, reducer, mechanical steering gear, and livestock battery power supply.